Tips & Tricks
This is the page for tips and Tricks – hope they are of some help.
Fitting up the Ozhitch is quite an easy job really.
All that’s required is to remove your current tow-ball, place the OzHitch tow-tongue section over the tow tongue, line up the holes and insert the bolt into the same hole the tow-ball was removed from. Tighten the bolt up and you are ready to connect.
Two benefits from this is the bolt thread will never get damaged when traversing rocks or coming of a barge ramp etc. This also gives better departure angles offroad without the lower hanging bolt thread.
Know your vehicle and trailers limitations
My first towing tip is one of the most important that very few people ever consider. I’ll post this in questions.
- How much is the maximum load including gear not supposed to exceed? Read below.
- How much does your trailer/caravan weigh unloaded?
- Do you know how much gear you have packed in weight in your trailer or van?
- Does your trailer hitch have the correct load ratings?
Loading your trailer safely
So here is my first tip. When you pack a camper trailer or caravan for its first time outing always go over a weighbridge and find out if you are within the trailers maximum load capacity. Why because a huge amount of accidents happen from overloading. You also need to check the vehicle manufacturers maximum allowable towing capacity. Every vehicle is different. Every trailer hitch also has different load limits.
What about the weight range of the tyres on the trailer / van? Are they a light truck tyre? Can they carry the load?
Now remember just because its under weight this time doesn’t mean its going to be under weight next time. Different trip types require different gear hence the change in overall weight. Believe me its very easy to get caught out.
I once had a customer who was complaining that the springs on his camper trailer were rubbish and not of a good quality. So I suggested he bring it round fully loaded so I could see the problem they were experiencing.
I asked Tony what he thought his trailer weighed, as I knew it had a max capacity of around the 900kg. He suggested quite firmly that the things they had packed were mostly light things and there was no way they were anywhere near the max capacity of 900kg.
The trained eye could see it was way over so without arguing I suggested we go for a drive to the local weigh bridge. We did and this is where his eyes nearly popped out of his head when he saw the weigh bridge meter hit 1350kg and he didn’t even have the tinny on the top he usually carried. That’s 450kg over weight. The only problem he had was to much gear. So I reckon you can imagine what a surprise he had. Its easier than you think.
If your trailer is overloaded, your cars towing capacity exceeded, your trailer hitch capacity is exceeded…. etc what chance have you got in an emergency stop. NONE. and how is your insurance affected. Have a look at the safe towing information booklet in our Downloads section.
These letters might be written on the side of your trailer or van:
(ATM) Aggregate Trailer Mass is the total mass of the fully laden trailer when carrying the maximum load recommended by the manufacturer. This includes any mass imposed onto the drawing vehicle (drawbar down weight) when the combination vehicle is resting on a horizontal supporting plane.
(GTM) Gross Trailer Mass is the mass transmitted to the ground by the axle or axles of the trailer when coupled to a drawing vehicle and carrying its maximum load approximately uniformly distributed over the load bearing area.